How to Connect Devices to your Computer (T6 Charge Case)
- Connect the power adapter cable from the power source outlet to the power cable port on the charge case. The power light in the case will turn on when the case is powered.
- Place the devices into their individual charge case slots; ensure the devices are facing toward the front of the case (device ID's facing back to hinge). This will cause the devices to start charging automatically which is indicated by a flashing and rotating LED light around the power button. When the device is fully charged the LED will go solid.
- If you do not have a USB booster, connect the USB cable directly from the charge case outlet to the computer USB port. Once the devices are successfully connected to the computer, the LED around the power button will turn blue but will remain in a flashing or a solid state depending on the charge state of the device.
Using a USB Booster
If you're connecting more than 11 units, you may require a USB booster in order for your computer to recognise all of the devices at once.
- To use a USB booster, connect the computer to the USB booster using the USB cable. The booster is ready for use when one light is solid and the second is a steady flash. If it's the first time connecting the booster, allow for some time (1-2 minutes) for the driver to install on the computer before using.
- Connect the booster to the charge case using the booster adapter cable.
- Connect the power adapter cable from the power source outlet to the power cable port on the charge case. The power light in the case will turn on when the case is powered.
-
Once the devices are successfully connected to the computer, the LED around the power button will turn blue but will remain in a flashing/rotating or a solid state depending on the charge state of the device.
Note: if you are using more than 1 booster (to connect multiple charge cases to your PC), ensure each booster is of a different type - this can be determined by the sticker on the bottom of the booster.